7 Trim Router Tips Keene NH
Waste services, porta potty, jetting, portable toilet rentals, septic solutions, locating septic tanks, septic tank repair, septic tank cleaning, septic tank filters, septic tank services, snaking, camera service, septic trouble shooting, hand wash station rentals, septic design, septic installation, septic maintenance
24/7 Emergency Service
M-SA 6 am - 10 pm
SU 8 am - 8 pm
7 Trim Router Tips
7 Trim Router Tips
1. Protect the Plastic Laminate
Laminate trim routers are amazing little machines. Their light weight and compact size make them exceptionally easy to use. Although they are designed primarily for trimming plastic laminate (p-lam), they also work great for light-duty wood routing.
Trim router motors range from 3.8 to 7.5 amps and run at speeds as high as 30,000 rpm. Add a base and the trim router weighs between 3 and 4-1/2 lbs. All models use only a 1/4-in. collet. You can buy a variety of bases and accessories (see Sources, page 4). Prices range from $80 for just the router with a standard base to $250 for a kit with several accessories.
Understanding what each of these accessories is capable of doing is the secret behind getting the most from your trim router. These accessories make the trim router very precise.
Apply a lubricant, such as wax, soap or Trim Ease (a commercial product available from p-lam and trim bit distributors), to the plastic laminate's face when you use self-piloting bits. The lubricant protects the p-lam from burning or marring. Self-piloting bits are available in flush-trim or bevel-trim profiles. The flush trim (shown here) is used when you want to leave a flat, square corner. Its single cutting flute makes it fast-cutting. A solid carbide self-piloting trim bit costs $8 to $10, which is about half of what a ball-bearing-guided trimming bit costs. Ball-bearing-guided bits greatly reduce the risk of marring and can be used without a lubricant. The bearings do wear out, so you should replace them as soon as they show signs that they're not spinning freely. It's also important to keep them clean of built-up glue. Ball-bearing-guided trim bits are available in either a flush-trim or bevel-trim profile. The bevel profile (shown here) is used when you want to ease the edge to make it friendlier to the touch and reduce its chance of chipping when bumped. Ball-bearing-guided trim bits cost $12 to $24 each.# 3. Mar-Proof Routing
Use a ball-bearing guide attachment when you want to totally eliminate the chance of marring the finished surface or when you want to leave an overhang on the part that you are trimming. A nonpiloted trim bit is used with this guide. The bit is a combination flush and bevel cut. You can trim straight or curved surfaces with this setup.
4. Get a Super-Straight Cut
Use a straight guide when trimming against the substrate material. The straight guide bridges the small voids or gaps common in particleboard and plywood. The result is a straighter edge on the p-lam. This is important when another p-lam piece will be laminated to this edge. Straight edge guides do not work on curves or close in inside corners. A regular straight bit works fine with the straight guide.