American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 

Clean Your Disc Sander Brookings SD

Remove the disc sander's table and lower guard or dust shroud. If you can, tilt yoursander so the disc is horizontal. Squirt some Goo Gone on the disc andlet it soak for a few minutes. Then scrub the disc with a smallfine-bristle wire brush.

Lowe's of Brookings
605-696-2730
812 25th Ave Brookings, SD, 57006
Brookings, SD
 
Homestead Building Supplies
(605) 692-6191
823 S Main Avenue
Brookings, SD
 
Brookings Rent-All
(605) 697-5544
803 Main Avenue South
Brookings, SD
 
J & K Building Center
(605) 997-3714
110 S Wind
Flandreau, SD
 
Winner True Value
(605) 842-1830
205 Main
Winner, SD
 
Fastenal- Brookings
605-697-6631
1321 Main Avenue South Brookings, SD, 57006
Brookings, SD
 
Lowe's
(605) 696-2730
812 25Th Avenue
Brookings, SD
Hours
M-SA 7 am - 9 pm
SU 8 am - 8 pm

Ace Hardware
(605) 697-5223
710 22nd Ave S, Brookings Mall
Brookings, SD
 
The Home Depot
(605)361-7439
2523 S Louise Ave
Sioux Falls, SD
Hours
Mon-Sat: 6:00am-9:00pm
Sun: 8:00am-8:00pm

Homestead Building Supplies
(605) 439-3161
Highway 10 West
Leola, SD
 

Clean Your Disc Sander

Clean Your Disc Sander


 

Here's a quick way to get rid of the globs of adhesive that remain on the surface of your disc sander after you remove worn out abrasive sheets. Goo Gone (available at hardware stores and home centers) attacks this problem like nobody's business. Goo Gone is citrus based, so it's not as harsh as paint solvents.

Remove the disc sander's table and lower guard or dust shroud. If you can, tilt yoursander so the disc is horizontal. Squirt some Goo Gone on the disc andlet it soak for a few minutes. Then scrub the disc with a smallfine-bristle wire brush. When the adhesive residue is all dissolved,wipe it off the disc with paper towels. Clean the disc with water toremove any remaining Goo Gone solution and dry the disc.

Source
Magic American Products, (800) 321-6330 www.googone.com, Goo Gone, 8 fl. oz. bottle, $5.

Click here to read the rest of the article from American Woodworker