American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 
» » »

Curved Scrapers Cody WY

Here's the inside scoop on those inside curves. It's a lot easier to get good results if you concentrate on creating a hook on one side only. Here's how it works: Start by creating a slight bevel on the edge (Photo 1). Then remove the wire edge (Photo 2). Finally, use your burnisher to roll the cutting hook (Photo 3).

Aldrich Home Center Of Cody
(307) 587-2263
308 19th Street
Cody, WY
 
Cody Ace Hardware
(307) 587-8555
2201 17th St, K-Mart and McDonald's
Cody, WY
 
Bloedorn Lumber Bldg Materials
(307) 587-2223
1902 Big Horn Ave
Cody, WY
 
The Home Depot
(307)632-2897
1740 Fleischli Pkwy
Cheyenne, WY
Hours
Mon-Sat: 7:00am-9:00pm
Sun: 7:00am-8:00pm

The Home Depot
(307)674-6669
2050 Coffeen Avenue
Sheridan, WY
Hours
Mon-Sat: 7:00am-8:00pm
Sun: 8:00am-8:00pm

Titan Truss
(307) 587-2187
2828 Chopper Lane
Cody, WY
 
Gambles
(307) 587-4461
1007 12th Street
Cody, WY
 
Diamond Concrete Design
(307) 222-4730
721 15th Street, Suite A
Cody, WY
 
The Home Depot
(307)472-6505
4900 East 2nd Street
Casper, WY
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 7:00am-8:00pm

The Home Depot
(307)686-8128
1105 E Boxelder Road
Gillette, WY
Hours
Mon-Sat: 7:00am-9:00pm
Sun: 7:00am-8:00pm

Curved Scrapers

Curved Scrapers



Sharpening Curved Scrapers

Q. I'm struggling to get a good cutting edge on my concave card scraper. Any tips?

A. Here's the inside scoop on those inside curves. It's a lot easier to get good results if you concentrate on creating a hook on one side only. Here's how it works: Start by creating a slight bevel on the edge (Photo 1).  Then remove the wire edge (Photo 2). Finally, use your burnisher to roll the cutting hook (Photo 3).

PHOTO 1:
File a slight bevel on the curve. With the scraper held in a vise, push a chainsaw file at a slight angle until you feel a continuous wire edge on the high side of the bevel.

PHOTO 2:
Remove the wire edge with
a super-fine diamond paddle. Because you have created a beveled edge, the wire edge will only form on the high side of the bevel.

PHOTO 3:
Use a burnisher to roll the edge and create the cutting hook. Hold the burnisher almost flat and use firm pressure to form the cutting hook. A drop or two of light machine oil helps.


Sources
Woodcraft, (800) 225-1153, www.woodcraft.com, Crown Round Scraper Burnisher, #14256, $19
Diamond Homing Stick,  #O8S15, $6. Hardware store, Chainsaw file, $3.

Click here to read the rest of the article from American Woodworker