American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 

Double Scrollsaw Blade Life Kalispell MT

When the scrollsaw blade gets dull, it’s really only dull on the bottom half, because the wood is usually less than 1/2 in. thick. To get more life out of the blade, you can make an auxiliary table that raises the workpiece, so you can cut with the top half of the blade when the bottom half gets dull.

The Home Depot
(406)755-5333
2455 Highway 93 North
Kalispell, MT
Hours
Mon-Sat: 6:00am-9:00pm
Sun: 8:00am-7:00pm

Northwest Drywall & Bldg Sply
(406) 752-2644
160 8th Ave
Kalispell, MT
 
Wright's Kalispell Lmbr.
(406) 257-3625
800 W. Idaho
Kalispell, MT
 
Kalispell - Auth Hometown
(406) 755-5678
1105 Us Highway 2 W
Kalispell, MT
Store Hours
Hometown Dealers
Store Type
Hometown Dealers
Hours
Mon:9.5-19
Tue:9.5-19
Wed:9.5-19
Thu:9.5-19
Fri:9.5-19
Sat:9-18
Sun:11-4
Store Features
Mon:9.5-19
Tue:9.5-19
Wed:9.5-19
Thu:9.5-19
Fri:9.5-19
Sat:9-18
Sun:11-4

Murdoch's Ranch & Home Supply
(406) 755-4747
2330 Hwy 93 South
Kalispell, MT
 
Western Building Center
(406) 755-6411
1745 3rd Ave East
Kalispell, MT
 
Cenex Harvest States Cooperatives
(406) 755-7427
150 1st Ave West N
Kalispell, MT
 
Montana Ace - Kalispell
(406) 755-9701
130 N Meridian Rd, Eisinger Motors
Kalispell, MT
 
Cardinal True Value
(406) 755-5220
16 7th Ave West
Kalispell, MT
 
Cardinal True Value
(406) 752-4221
2148 Hwy 2 East
Kalispell, MT
 

Double Scrollsaw Blade Life

Double Scrollsaw Blade Life

When my scrollsaw blade gets dull, it’s really only dull on the bottom half, because the wood I cut is usually less than 1/2 in. thick. To get more life out of my blade, I made an auxiliary table that raises the workpiece, so I can cut with the top half of the blade when the bottom half gets dull.

I made the table by screwing together pieces of 3/4-in. melamine and 1/2-in. plywood and edge-banding all four sides. I drilled a 7-16-in. hole in the center for the blade and cut a 1/16-in. slot in from the back so I can slip the table on and off without removing the blade. 

I filed slight chamfers on the top of the hole and slot, so they won’t catch on the workpiece. I also widened the slot at the back, so it easily slips around the blade. Cleats glued on the bottom hold the table securely in place on the saw (see photo, below). 

I’ve discovered that it takes less time to install the table than it takes to change a blade, so in addition to saving a few bucks in scrollsaw blades, my table saves time, too. 

Click here to read the rest of the article from American Woodworker