American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 
» » ยป

Drawer-Slide Outfeed Table Brookings SD

In my garage shop, large tools have to be mobile and storable, so I attached this collapsing outfeed support to my saw. It slides on 100-lb. full-extension drawer slides. Extended, the roller sits 36 in. behind the blade, so I can rip boards as long as 6 ft. I can clamp the arms in any position to support shorter boards.

Brookings Rent-All
(605) 697-5544
803 Main Avenue South
Brookings, SD
 
Lowe's of Brookings
605-696-2730
812 25th Ave Brookings, SD, 57006
Brookings, SD
 
Fastenal- Brookings
605-697-6631
1321 Main Avenue South Brookings, SD, 57006
Brookings, SD
 
J & K Building Center
(605) 997-3714
110 S Wind
Flandreau, SD
 
Wilson True Value Hardware
(605) 724-2796
700 Main St
Armour, SD
 
Lowe's
(605) 696-2730
812 25Th Avenue
Brookings, SD
Hours
M-SA 7 am - 9 pm
SU 8 am - 8 pm

Ace Hardware
(605) 697-5223
710 22nd Ave S, Brookings Mall
Brookings, SD
 
Homestead Building Supplies
(605) 692-6191
823 S Main Avenue
Brookings, SD
 
The Home Depot
(605)361-7439
2523 S Louise Ave
Sioux Falls, SD
Hours
Mon-Sat: 6:00am-9:00pm
Sun: 8:00am-8:00pm

Homestead Building Supplies
(605) 763-5046
201 E. Main St
Beresford, SD
 

Drawer-Slide Outfeed Table

Drawer-Slide Outfeed Table

In my garage shop, large tools have to be mobile and storable, so I attached this collapsing outfeed support to my saw. It slides on 100-lb. full-extension drawer slides. Extended, the roller sits 36 in. behind the blade, so I can rip boards as long as 6 ft. I can clamp the arms in any position to support shorter boards. Closed, the roller rests 16 in. behind the blade, so it doesn't interfere with the blade guard assembly or with the miter gauge bar during crosscuts.

The support is built like an inside-out drawer. First I bolted support arms onto the saw's cabinet. I had to extend the left arm to allow tilting the motor. Then I installed the drawer slides and the extension arms. On my saw, 20-in. slides were the longest that would fit. I fastened the extension arms securely with a wide board to minimize racking. I mounted the roller on top, centered behind the blade. To position everything correctly during construction, I clamped the roller flush with the saw table.

Sources

HTC Products Inc., (800) 624-2027
22-in. roller with bracket, #HU-22, $19.

Woodworker's Hardware, (800) 383-0130
www.wwhardware.com
100-lb. full-extension 20-in. drawer slides, #KV8414 B20, $14 a set.


Click here to read the rest of the article from American Woodworker