American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 

Elegant Table Top Fasteners Ballwin MO

To make the buttons, cut dadoes in a long block (see photo). Drill andcountersink holes for the screws and then chamfer the long edges. Sawapart the blocks and chamfer the ends with a file or disc sander.

The Home Depot
(636)207-8875
13929 Manchester Rd
Ballwin, MO
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Woodcraft - St. Louis/Maryland Heights
(314) 993-0413
2077 Congressional Drive
St. Louis, MO

Data Provided by:
The Home Depot
(636)922-1281
6190 Mid River Mall Dr
St Peter, MO
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(636)936-9494
3891 Mexico Rd
Saint Charles, MO
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(636)287-1111
3865 Vogel Rd
Arnold, MO
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(636)536-0675
390 Thf Boulevard
Chesterfield, MO
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(314)909-7771
10890 Sunset Hills Plaza
Saint Louis, MO
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(314)647-6050
1603 S Hanley Rd
Brentwood, MO
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(314)733-1534
8901 Page Avenue
Overland, MO
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(314)291-5288
11215 St Charles Rock Rd
Bridgeton, MO
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Data Provided by:

Elegant Table Top Fasteners

Elegant Table Top Fasteners

On my best work, I want the bottom of my project to look as good asthe top. That's when I make an old-fashioned set of wooden tabletopfasteners, or "buttons," rather than use the modern stamped-steel type.

A button allows a solid-wood top to expand and contract through theseasons. When the top's grain runs parallel to the rail, the buttonslides in and out of the slot as the top slowly moves. When the grainruns at right angles to the rail, the button slides side to side.

To make the buttons, cut dadoes in a long block (see photo). Drill andcountersink holes for the screws and then chamfer the long edges. Sawapart the blocks and chamfer the ends with a file or disc sander.

 


Click here to read the rest of the article from American Woodworker