American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 

Elegant Table Top Fasteners Charlotte NC

To make the buttons, cut dadoes in a long block (see photo). Drill andcountersink holes for the screws and then chamfer the long edges. Sawapart the blocks and chamfer the ends with a file or disc sander.

The Home Depot
(704)365-1291
1220 N Wendover Rd
Charlotte, NC
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(704)596-1550
8135 University Cty Blvd
Charlotte, NC
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(704)544-2877
10210 Centrum Pkwy
Pineville, NC
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(704)535-6982
9501 Albemarle Rd
Charlotte, NC
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Woodcraft - Matthews, NC
(704) 847-8300
1725 Windsor Square Drive
Matthews, NC

Data Provided by:
The Home Depot
(704)522-8383
4750 South Boulevard
Charlotte, NC
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(704)504-9836
14310 Rivergate Pkwy
Charlotte, NC
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(704)814-6131
5415 Ballantyne Cmmns Pk
Charlotte, NC
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(704)845-9200
1837 Matthews Twnsp Pkwy
Matthews, NC
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(704)865-9532
2870 E Franklin Blvd
Gastonia, NC
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Data Provided by:

Elegant Table Top Fasteners

Elegant Table Top Fasteners

On my best work, I want the bottom of my project to look as good asthe top. That's when I make an old-fashioned set of wooden tabletopfasteners, or "buttons," rather than use the modern stamped-steel type.

A button allows a solid-wood top to expand and contract through theseasons. When the top's grain runs parallel to the rail, the buttonslides in and out of the slot as the top slowly moves. When the grainruns at right angles to the rail, the button slides side to side.

To make the buttons, cut dadoes in a long block (see photo). Drill andcountersink holes for the screws and then chamfer the long edges. Sawapart the blocks and chamfer the ends with a file or disc sander.

 


Click here to read the rest of the article from American Woodworker