American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 

Elegant Table Top Fasteners East Amherst NY

To make the buttons, cut dadoes in a long block (see photo). Drill andcountersink holes for the screws and then chamfer the long edges. Sawapart the blocks and chamfer the ends with a file or disc sander.

The Home Depot
(716)633-9200
4139 Transit Road
Williamsville, NY
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(716)639-9600
2065 Niagara Falls Blvd
Amherst, NY
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(716)439-4898
5730 S Transit Rd
Lockport, NY
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(716)871-8800
2100 Elmwood Avenue
Buffalo, NY
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Advantage Trim & Lumber Co
(716) 827-3915
601 Ohio St
Buffalo, NY

Data Provided by:
Rockler Woodworking and Hardware #11
(716) 631-8922
5085 Transit Rd
Buffalo, NY

Data Provided by:
The Home Depot
(716)895-6680
300 Thruway Plaza Dr
Cheektowaga, NY
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

RC Tonewoods
(716) 873-6043
1109 Military Road
Buffalo, NY

Data Provided by:
The Home Depot
(716)677-7445
1881 Ridge Road
West Seneca, NY
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Woodcraft - Buffalo, NY
(716) 674-0795
1900 Ridge Road
West Seneca, NY

Data Provided by:
Data Provided by:

Elegant Table Top Fasteners

Elegant Table Top Fasteners

On my best work, I want the bottom of my project to look as good asthe top. That's when I make an old-fashioned set of wooden tabletopfasteners, or "buttons," rather than use the modern stamped-steel type.

A button allows a solid-wood top to expand and contract through theseasons. When the top's grain runs parallel to the rail, the buttonslides in and out of the slot as the top slowly moves. When the grainruns at right angles to the rail, the button slides side to side.

To make the buttons, cut dadoes in a long block (see photo). Drill andcountersink holes for the screws and then chamfer the long edges. Sawapart the blocks and chamfer the ends with a file or disc sander.

 


Click here to read the rest of the article from American Woodworker