American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 

Elegant Table Top Fasteners Loudon TN

To make the buttons, cut dadoes in a long block (see photo). Drill andcountersink holes for the screws and then chamfer the long edges. Sawapart the blocks and chamfer the ends with a file or disc sander.

The Home Depot
(865)986-6116
250 Abbie Drive
Lenoir City, TN
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(865)983-6200
943 Foot Hills Mall Dr
Maryville, TN
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Co/Op Ace Hardware
(865) 458-2057
2084 W Lee Hwy
Loudon, TN
 
Sweetwater - D
(423) 337-2870
902 S Main St
Sweetwater, TN
Store Hours
Miscellaneous
Store Type
Miscellaneous
Hours
Mon:8-22
Tue:8-22
Wed:8-22
Thu:8-22
Fri:8-22
Sat:8-22
Sun:8-21
Store Features
Mon:8-22
Tue:8-22
Wed:8-22
Thu:8-22
Fri:8-22
Sat:8-22
Sun:8-21

UNITED RENTALS/Knoxville, TN
(865) 693-5761
10224 Kingston Pike Knoxville, TN, 37922
Knoxville, TN
 
The Home Depot
(865)691-9500
9361 Kingston Pike
Knoxville, TN
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Fastenal- Loudon
865-458-0404
155A Natalie Blvd Loudon, TN, 37774
Loudon, TN
 
Ace Hardware of Dixie Lee Jct
(865) 988-5285
19670 Highway 11 E, WATT ROAD
Dixie Lee Jct, TN
 
Foothills Farmers Co-op
(423) 337-3551
776 New Highway 68
Sweetwater, TN
 
Browder's Ace Hardware
(865) 376-7606
1100 Ladd Landing Blvd, Ladd Landing Shopping Center
Kingston, TN
 

Elegant Table Top Fasteners

Elegant Table Top Fasteners

On my best work, I want the bottom of my project to look as good asthe top. That's when I make an old-fashioned set of wooden tabletopfasteners, or "buttons," rather than use the modern stamped-steel type.

A button allows a solid-wood top to expand and contract through theseasons. When the top's grain runs parallel to the rail, the buttonslides in and out of the slot as the top slowly moves. When the grainruns at right angles to the rail, the button slides side to side.

To make the buttons, cut dadoes in a long block (see photo). Drill andcountersink holes for the screws and then chamfer the long edges. Sawapart the blocks and chamfer the ends with a file or disc sander.

 


Click here to read the rest of the article from American Woodworker