American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 

Elegant Table Top Fasteners Meridian ID

To make the buttons, cut dadoes in a long block (see photo). Drill andcountersink holes for the screws and then chamfer the long edges. Sawapart the blocks and chamfer the ends with a file or disc sander.

The Home Depot
(208)887-9699
1100 S Progress
Meridian, ID
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Woodcraft - Boise, ID
(208) 338-1190
6883 West Overland Road
Boise, ID

Data Provided by:
The Home Depot
(208)388-8500
3639 E Federal Way
Boise, ID
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(208) 388-8500
3639 S Federal Way
Boise, ID
 
D & B Supply Co
(208) 887-0949
1725 Fairview Ave
Meridian, ID
 
The Home Depot
(208)375-1186
1200 Milwaukee Street
Boise, ID
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(208)939-7648
2808 E State Street
Eagle, ID
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(208)461-6476
2003 N Cassia St
Nampa, ID
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Lowe's
(208) 855-5160
305 West Overland Road
Meridian, ID
Hours
M-SA 6 am - 10 pm
SU 8 am - 8 pm

Fastenal- Boise
208-375-9495
134 North Cloverdale Boise, ID, 83714
Boise, ID
 
Data Provided by:

Elegant Table Top Fasteners

Elegant Table Top Fasteners

On my best work, I want the bottom of my project to look as good asthe top. That's when I make an old-fashioned set of wooden tabletopfasteners, or "buttons," rather than use the modern stamped-steel type.

A button allows a solid-wood top to expand and contract through theseasons. When the top's grain runs parallel to the rail, the buttonslides in and out of the slot as the top slowly moves. When the grainruns at right angles to the rail, the button slides side to side.

To make the buttons, cut dadoes in a long block (see photo). Drill andcountersink holes for the screws and then chamfer the long edges. Sawapart the blocks and chamfer the ends with a file or disc sander.

 


Click here to read the rest of the article from American Woodworker