American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 

Eliminate Fuzzy Fillets Anderson IN

The Quadra-Cut bit left a near-perfect surface requiring only a light sanding before finishing (Photo A). A standard bit of the same profile left a lot of fuzz and tearout at the top of the fillet (Photo B). Needless to say, we were very impressed with this bit design.

The Home Depot
(317)774-8087
3300 Conner Street
Noblesville, IN
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Fastenal- Anderson
765-643-2975
702 West 8th St Anderson, IN, 46016
Anderson, IN
 
LOWE'S OF ANDERSON, IND.
765 641-2586
3335 SOUTH SCATTERFIELD RD ANDERSON, IN, 46013
Anderson, IN
 
Shumaker Electric Co.
(765) 378-7212
9044 S County Rd 800 West
Daleville, IN
 
Tops Home Center #55
(765) 552-2212
2927 South A St
Elwood, IN
 
Mounds Mall S/C
(765) 683-4600
2109 S Scatterfield Rd
Anderson, IN
Store Hours
Sears Stores
Store Type
Sears Stores
Hours
Mon:10-21
Tue:10-19.5
Wed:10-21
Thu:10-21
Fri:10-21
Sat:10-21
Sun:12-17.5
Store Features
Mon:10-21
Tue:10-19.5
Wed:10-21
Thu:10-21
Fri:10-21
Sat:10-21
Sun:12-17.5

Lowe's
(765) 641-2586
3335 South Scatterfield Road
Anderson, IN
Hours
M-SA 6:30 am - 10 pm
SU 8 am - 8 pm

Northgate True Value Hardware
(765) 642-2400
2400 Broadway St
Anderson, IN
 
Mathews True Value Home Center
(765) 778-2411
1810 Fairfield Lane
Pendleton, IN
 
Fastenal- Muncie
765-282-6528
5794 W. Kilgore Ave Muncie, IN, 47304
Muncie, IN
 

Eliminate Fuzzy Fillets

Eliminate Fuzzy Fillets

   

Freud's new Quadra-Cut router bits produce routed profiles with little or no tear out or fuzz even on cross-grain cuts. These unique, patented bits employ four cutting edges instead of two. The large profile cutters remove most of the stock with an upshear cut. Then a pair of downshear cutters makes the final cut to produce an ultra clean edge with no fuzz or splinters at the top surface. Freud is introducing the new Quadra-Cut technology in select edge-forming bits with 1⁄2-in. shanks. We got our hands on a round-over bit and tried it out on some red oak panels. The results were amazing (see photos above). Both bits were brand new, but the difference in cut quality, especially at the fillet on the top, was quite noticeable. We made full-profile cuts in a single pass to really put the design to the test. The Quadra-Cut bit left a near-perfect surface requiring only a light sanding before finishing (Photo A). A standard bit of the same profile left a lot of fuzz and tearout at the top of the fillet (Photo B). Needless to say, we were very impressed with this bit design.

Source
Freud, www.freudtools.com 

Click here to read the rest of the article from American Woodworker