American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 
» » »

Eliminate Fuzzy Fillets Athens OH

The Quadra-Cut bit left a near-perfect surface requiring only a light sanding before finishing (Photo A). A standard bit of the same profile left a lot of fuzz and tearout at the top of the fillet (Photo B). Needless to say, we were very impressed with this bit design.

C&e True Value Hdw.
(740) 593-7705
470 Richland Ave
Athens, OH
 
LOWE'S OF ATHENS, OH
740 589-3750
983 EAST STATE STREET ATHENS, OH, 45701
Athens, OH
 
Crescent & Sprague Supply
(740) 593-8141
751 W Union St
Athens, OH
 
Saving Hardware
(740) 753-1987
129 W Washington
Nelsonville, OH
 
Dettwiller True Value Lumber
(740) 992-5500
634 E Main St
Pomeroy, OH
 
Lowe's
(740) 589-3750
983 East State Street
Athens, OH
Hours
M-SA 7 am - 9 pm
SU 8 am - 8 pm

Athens - Auth Hometown
(740) 594-8400
743 F2 East State Street
Athens, OH
Store Hours
Hometown Dealers
Store Type
Hometown Dealers
Hours
Mon:9-19
Tue:9-19
Wed:9-19
Thu:9-19
Fri:9-19
Sat:9-18
Sun:12-17
Store Features
Mon:9-19
Tue:9-19
Wed:9-19
Thu:9-19
Fri:9-19
Sat:9-18
Sun:12-17

The Plains True Value
(740) 797-2582
70 N Plains Rd Ste 101
The Plains, OH
 
Darby Land Lumber
(740) 767-2762
17 Main Street
Glouster, OH
 
Baum True Value Store
(740) 985-3301
46384 State Rte 248
Chester, OH
 

Eliminate Fuzzy Fillets

Eliminate Fuzzy Fillets

   

Freud's new Quadra-Cut router bits produce routed profiles with little or no tear out or fuzz even on cross-grain cuts. These unique, patented bits employ four cutting edges instead of two. The large profile cutters remove most of the stock with an upshear cut. Then a pair of downshear cutters makes the final cut to produce an ultra clean edge with no fuzz or splinters at the top surface. Freud is introducing the new Quadra-Cut technology in select edge-forming bits with 1⁄2-in. shanks. We got our hands on a round-over bit and tried it out on some red oak panels. The results were amazing (see photos above). Both bits were brand new, but the difference in cut quality, especially at the fillet on the top, was quite noticeable. We made full-profile cuts in a single pass to really put the design to the test. The Quadra-Cut bit left a near-perfect surface requiring only a light sanding before finishing (Photo A). A standard bit of the same profile left a lot of fuzz and tearout at the top of the fillet (Photo B). Needless to say, we were very impressed with this bit design.

Source
Freud, www.freudtools.com 

Click here to read the rest of the article from American Woodworker