American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 
» » »

Eliminate Fuzzy Fillets Marion IA

The Quadra-Cut bit left a near-perfect surface requiring only a light sanding before finishing (Photo A). A standard bit of the same profile left a lot of fuzz and tearout at the top of the fillet (Photo B). Needless to say, we were very impressed with this bit design.

The Home Depot
(319)294-0480
4501 1st Avenue SE
Cedar Rapids, IA
Hours
Mon-Sat: 6:00am-9:00pm
Sun: 8:00am-8:00pm

Fastenal- Marion
319-377-5928
1100 44th Street Marion, IA, 52302
Marion, IA
 
Lowe's of Cedar Rapids
319-294-3780
5300 Blairs Forest Blvd NE Cedar Rapids, IA, 52402
Cedar Rapids, IA
 
O'Donnell Ace Hardware
(319) 395-7770
3825 Center Point Rd NE, Between Collins and Glass on Center Pointe Road
Cedar Rapids, IA
 
Blairs Ferry True Value
(319) 832-1343
1100 Ne Blairs Ferry Road
Cedar Rapids, IA
 
Marion Ace Hardware
(319) 373-7704
3200 7th Ave
Marion, IA
 
Campbell Supply Co/Cedar Rapid
319 395 0991
2127 North Towne Lane NE Cedar Rapids, IA, 52410
Cedar Rapids, IA
 
Acme Tools- Cedar Rapids
319-363-2211
1943 Blairs Ferry Rd NE Cedar Rapids, IA, 52402
Cedar Rapids, IA
 
Lowe's
(319) 294-3780
5300 Blairs Forest Blvd Ne
Cedar Rapids, IA
Hours
M-SA 6:30 am - 9 pm
SU 8 am - 7 pm

Kmart 4289 / Cross Merch
(319) 377-6303
180 Collins Rd Ne
Cedar Rapids, IA
Store Hours
Miscellaneous
Store Type
Miscellaneous
Hours
Monday To Friday Working Hours is :8-22 and for Sat:8-22
Sun:8-21
Store Features
Monday To Friday Working Hours is :8-22 and for Sat:8-22
Sun:8-21

Eliminate Fuzzy Fillets

Eliminate Fuzzy Fillets

   

Freud's new Quadra-Cut router bits produce routed profiles with little or no tear out or fuzz even on cross-grain cuts. These unique, patented bits employ four cutting edges instead of two. The large profile cutters remove most of the stock with an upshear cut. Then a pair of downshear cutters makes the final cut to produce an ultra clean edge with no fuzz or splinters at the top surface. Freud is introducing the new Quadra-Cut technology in select edge-forming bits with 1⁄2-in. shanks. We got our hands on a round-over bit and tried it out on some red oak panels. The results were amazing (see photos above). Both bits were brand new, but the difference in cut quality, especially at the fillet on the top, was quite noticeable. We made full-profile cuts in a single pass to really put the design to the test. The Quadra-Cut bit left a near-perfect surface requiring only a light sanding before finishing (Photo A). A standard bit of the same profile left a lot of fuzz and tearout at the top of the fillet (Photo B). Needless to say, we were very impressed with this bit design.

Source
Freud, www.freudtools.com 

Click here to read the rest of the article from American Woodworker