American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 
» » »

Eliminate Fuzzy Fillets Oshkosh WI

The Quadra-Cut bit left a near-perfect surface requiring only a light sanding before finishing (Photo A). A standard bit of the same profile left a lot of fuzz and tearout at the top of the fillet (Photo B). Needless to say, we were very impressed with this bit design.

The Home Depot
(920)993-1123
653 N Westhill Blvd
Grand Chute, WI
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Lowe's
(920) 232-7423
1075 North Washburn Street
Oshkosh, WI
Hours
M-SA 6:30 am - 9 pm
SU 8 am - 7 pm

Lowe's of Oshkosh
920-232-7423
1075 North Washburn Street Oshkosh, WI, 54904
Oshkosh, WI
 
Kitz & Pfeil True Value Hdwe
(920) 236-3340
427 N Main St
Oshkosh, WI
 
Brazee Ace Hardware
(920) 722-1113
516 N Commercial St
Neenah, WI
 
Woodcraft - Fox Cities/Appleton, WI
(920) 730-9663
4731 Michael's Drive
Appleton, WI

Data Provided by:
M. Schettl Sales Incorporated
(920) 426-1681
5105 County Road S
Oshkosh, WI
 
Oshkosh - Auth Hometown
(920) 230-6777
2081 Witzel Avenue
Oshkosh, WI
Store Hours
Hometown Dealers
Store Type
Hometown Dealers
Hours
Mon:10-20
Tue:10-20
Wed:10-20
Thu:10-20
Fri:10-20
Sat:9-18
Sun:11-16
Store Features
Mon:10-20
Tue:10-20
Wed:10-20
Thu:10-20
Fri:10-20
Sat:9-18
Sun:11-16

Krueger True Value
(920) 722-1588
999 Winneconne Ave
Neenah, WI
 
LW Meyer- Neenah
(920) 722-4525
1375 Constitution Drive Neenah, WI, 54956
Neenah, WI
 
Data Provided by:

Eliminate Fuzzy Fillets

Eliminate Fuzzy Fillets

   

Freud's new Quadra-Cut router bits produce routed profiles with little or no tear out or fuzz even on cross-grain cuts. These unique, patented bits employ four cutting edges instead of two. The large profile cutters remove most of the stock with an upshear cut. Then a pair of downshear cutters makes the final cut to produce an ultra clean edge with no fuzz or splinters at the top surface. Freud is introducing the new Quadra-Cut technology in select edge-forming bits with 1⁄2-in. shanks. We got our hands on a round-over bit and tried it out on some red oak panels. The results were amazing (see photos above). Both bits were brand new, but the difference in cut quality, especially at the fillet on the top, was quite noticeable. We made full-profile cuts in a single pass to really put the design to the test. The Quadra-Cut bit left a near-perfect surface requiring only a light sanding before finishing (Photo A). A standard bit of the same profile left a lot of fuzz and tearout at the top of the fillet (Photo B). Needless to say, we were very impressed with this bit design.

Source
Freud, www.freudtools.com 

Click here to read the rest of the article from American Woodworker