American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 

Eliminate Fuzzy Fillets Summerville SC

The Quadra-Cut bit left a near-perfect surface requiring only a light sanding before finishing (Photo A). A standard bit of the same profile left a lot of fuzz and tearout at the top of the fillet (Photo B). Needless to say, we were very impressed with this bit design.

The Home Depot
(843)851-0468
190 Marymeade Dr
Summerville, SC
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(843)556-2447
2008 Magwood Rd
Charleston, SC
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Lowe's
(843) 486-4130
9600 Dorchester Road
Summerville, SC
Hours
M-SA 6 am - 10 pm
SU 8 am - 8 pm

Fastenal- Summerville
843-873-2774
412 E. 5th North Rd Summerville, SC, 29483
Summerville, SC
 
Warm Do it Best Hardware
(843) 871-4741
1410 Boone Hill Road
Summerville, SC
 
The Home Depot
(843)569-3773
7554 Northwood Blvd
Charleston, SC
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

LOWE'S OF SUMMERVILLE, S. C.
843 851-0066
1207 N. MAIN ST. SUMMERVILLE, SC, 29483
Summerville, SC
 
Lowe's
(843) 851-0066
1207 North Main Street
Summerville, SC
Hours
M-SA 6 am - 10 pm
SU 8 am - 8 pm

Ace Hardware of Summerville
(843) 875-7234
713 Old Trolley Rd
Summerville, SC
 
Lowe's of Northwest Charleston
843-486-4130
9600 Dorchester Rd Summerville, SC, 29485
Summerville, SC
 

Eliminate Fuzzy Fillets

Eliminate Fuzzy Fillets

   

Freud's new Quadra-Cut router bits produce routed profiles with little or no tear out or fuzz even on cross-grain cuts. These unique, patented bits employ four cutting edges instead of two. The large profile cutters remove most of the stock with an upshear cut. Then a pair of downshear cutters makes the final cut to produce an ultra clean edge with no fuzz or splinters at the top surface. Freud is introducing the new Quadra-Cut technology in select edge-forming bits with 1⁄2-in. shanks. We got our hands on a round-over bit and tried it out on some red oak panels. The results were amazing (see photos above). Both bits were brand new, but the difference in cut quality, especially at the fillet on the top, was quite noticeable. We made full-profile cuts in a single pass to really put the design to the test. The Quadra-Cut bit left a near-perfect surface requiring only a light sanding before finishing (Photo A). A standard bit of the same profile left a lot of fuzz and tearout at the top of the fillet (Photo B). Needless to say, we were very impressed with this bit design.

Source
Freud, www.freudtools.com 

Click here to read the rest of the article from American Woodworker