American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 

Fast Accurate Height Adjustments Lenoir City TN

The Angle Wright is a precision instrument that helps you make quick and accurate height adjustments of router bits, jointer knives and table saw blades. Made in the USA of anodized aluminum and steel, it features recessed brass adjustment knobs that allow the tool to be used flat on its side or in an upright position.

The Home Depot
(865)986-6116
250 Abbie Drive
Lenoir City, TN
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(865)983-6200
943 Foot Hills Mall Dr
Maryville, TN
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Woodcraft - Knoxville, TN
(865) 539-9330
8023 Kingston Pike
Knoxville, TN

Data Provided by:
Ace Hardware of Dixie Lee Jct
(865) 988-5285
19670 Highway 11 E, WATT ROAD
Dixie Lee Jct, TN
 
Fastenal- Loudon
865-458-0404
155A Natalie Blvd Loudon, TN, 37774
Loudon, TN
 
The Home Depot
(865)691-9500
9361 Kingston Pike
Knoxville, TN
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(865)425-0493
175 Laboratory Rd
Oak Ridge, TN
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(865)938-3574
2751 Schaad Road
Knoxville, TN
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Co/Op Ace Hardware
(865) 458-2057
2084 W Lee Hwy
Loudon, TN
 
UNITED RENTALS/Knoxville, TN
(865) 693-5761
10224 Kingston Pike Knoxville, TN, 37922
Knoxville, TN
 
Data Provided by:

Fast Accurate Height Adjustments

Fast Accurate Height Adjustments

 

    

The Angle Wright is a precision instrument that helps you make quick and accurate height adjustments of router bits, jointer knives and table saw blades. Made in the USA of anodized aluminum and steel, it features recessed brass adjustment knobs that allow the tool to be used flat on its side or in an upright position. The height gauge measures up to 3-1/4-in. in 1/32-in. graduations. The zero line ("0") on the slide block acts as a pointer. The micro-adjust knob is calibrated so that one-quarter turn equals 1/128-in. For ultra smooth operation, the slide block is dovetailed into hand-lapped ways in the body. The gauge's steel foot is 1/2-in.-wide, so you don't have to locate top dead center on your saw blade to obtain accurate measurements. Simply position the Angle Wright approximately where the tablesaw's blade reaches it's highest point. Gently rocking the blade as you lower the foot.
Decimal and metric scales are also available in 0.025-in.  and  1-mm. graduations. They both use vernier scales on the slide bar that permit readings to 0.001 inches.

Source
21st Century Scientific, (800) 448-3680, www.anglewright.com, Angle Wright, $135

Click here to read the rest of the article from American Woodworker