American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 
» » »

Jointing with a Planer Canby OR

The boards for my table were only 4-ft. long and the sled is about 6-in. longer. This technique works equally well for longer boards although you will need a longer sled and you may need additional shims along the sides.

The Home Depot
(503)723-3181
2002 Washington Street
Oregon City, OR
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 7:00am-8:00pm

The Home Depot
(503)639-3500
14800 SW Sequoia Parkway
Tigard, OR
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 7:00am-8:00pm

Rockler Woodworking and Hardware #17
(503) 672-7266
Beaverton Town Square Mall
Beaverton (Portland), OR

Data Provided by:
The Home Depot
(503)261-8543
10120 SE Washington St
Portland, OR
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 7:00am-8:00pm

Canby Ace Hardware
(503) 263-2500
1061 SW 1st Ave, Safeway Center on 99E
Canby, OR
 
The Home Depot
(503)925-8447
20260 SW Pacific Hwy
Sherwood, OR
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 7:00am-8:00pm

Woodcraft - Portland, OR
(503) 684-1428
12020 SW Main Street
Tigard, OR

Data Provided by:
The Home Depot
(503)469-4242
4401 Southwest 110th Ave
Beaverton, OR
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 7:00am-8:00pm

Woodcrafters
(800) 777-3709
212 NE 6th Ave
Portland, OR

Data Provided by:
Wilco Farm Stores - Canby
(503) 266-2213
195 S Hazel Dell Way
Canby, OR
 
Data Provided by:

Jointing with a Planer

Jointing with a Planer

    

 

I came across some wonderful oak boards for a small table I wanted to build. The problem was the boards were too wide for my jointer and I didn't want to rip them any narrower. I solved my dilemma with this planer sled that allows me to use my planer as a jointer. The trick is to keep the board from rocking during planing. A wood shim under the high corner is all it takes. I add hot-melt glue to the shim and all four corners of the board to keep them from shifting on the sled during planing. Once I have one side planed flat I take the board off the sled, flip it over and plane the other side. The boards for my table were only 4-ft. long and the sled is about 6-in. longer. This technique works equally well for longer boards although you will need a longer sled and you may need additional shims along the sides.

Back to Workshop Tips Index

Click here to read the rest of the article from American Woodworker