American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 

Jointing with a Planer Kernersville NC

The boards for my table were only 4-ft. long and the sled is about 6-in. longer. This technique works equally well for longer boards although you will need a longer sled and you may need additional shims along the sides.

The Home Depot
(336)744-2336
5721 University Parkway
Winston Salem, NC
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Global Veneer Sales, Inc.
(336) 885-5061
PO Box 5829
High Point, NC

Data Provided by:
The Home Depot
(336)883-0500
2300 N Main St
High Point, NC
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(336)659-1181
1000 Hanes Mall Blvd
Winston-Salem, NC
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(336)218-0655
4425 W Wendover Ave
Greensboro, NC
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(336)545-1125
3215 Brassfield Rd
Greensboro, NC
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(336) 545-1125
3215 Brassfield RD
Greensboro, NC
 
The Home Depot
(336) 659-1181
1000 Hanes Mall Blvd
Winston-Salem, NC
 
Woodcraft - Greensboro, NC
(336) 235-0900
504 Four Seasons
Greensboro, NC

Data Provided by:
Klingspor’s Woodworking Shop of Winston-Salem
(336) 768-9663
532 Hanes Mall BlvdPavilions Shopping Center
Winston-Salem, NC

Data Provided by:
Data Provided by:

Jointing with a Planer

Jointing with a Planer

    

 

I came across some wonderful oak boards for a small table I wanted to build. The problem was the boards were too wide for my jointer and I didn't want to rip them any narrower. I solved my dilemma with this planer sled that allows me to use my planer as a jointer. The trick is to keep the board from rocking during planing. A wood shim under the high corner is all it takes. I add hot-melt glue to the shim and all four corners of the board to keep them from shifting on the sled during planing. Once I have one side planed flat I take the board off the sled, flip it over and plane the other side. The boards for my table were only 4-ft. long and the sled is about 6-in. longer. This technique works equally well for longer boards although you will need a longer sled and you may need additional shims along the sides.

Back to Workshop Tips Index

Click here to read the rest of the article from American Woodworker