American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 

Rollers Ease Plywood Storage Vincennes IN

Plywood storage roller works great and it's simple to make. The following article has some tips to offer to help you build your own storage roller. So read on to get more details below.

Niehaus Home Center
(812) 882-2710
1023-1025 Main St
Vincennes, IN
 
Vincennes - Auth Hometown
(812) 886-0669
1815 N 6Th St
Vincennes, IN
Store Hours
Hometown Dealers
Store Type
Hometown Dealers
Hours
Mon:9-19
Tue:9-19
Wed:9-19
Thu:9-19
Fri:9-19
Sat:9-18
Sun:12-17
Store Features
Mon:9-19
Tue:9-19
Wed:9-19
Thu:9-19
Fri:9-19
Sat:9-18
Sun:12-17

Lowe's
(812) 895-0538
2700 North 6Th Street
Vincennes, IN
Hours
M-SA 7 am - 9 pm
SU 9 am - 7 pm

Greenwood Hardware Inc
(812) 254-1734
708 E Main St
Washington, IN
 
Lawrence County Ace Hardware
(618) 943-3762
2401 James St
Lawrenceville, IL
 
LOWE'S OF VINCENNES, IN
812 895-0538
2700 NORTH 6TH STREET VINCENNES, IN, 47591
Vincennes, IN
 
Fastenal- Vincennes
812-886-5877
2803 North 6th Street Vincennes, IN, 47591
Vincennes, IN
 
Mackey's Do it Best Hardware
(812) 735-2779
321 N Main Street
Bicknell, IN
 
Bender Lumber
(812) 254-7774
2112 East State
Washington, IN
 
Petersburg Hardware
(812) 354-8350
105 N 5th Street
Petersburg, IN
 

Rollers Ease Plywood Storage

Rollers Ease Plywood Storage

Before I installed these rollers, sliding plywood in and out of my storage rack used to wear me out. It also damaged the edges of the sheets. Now plywood sheets glide in and out.I cut the 2-1/2-in.-dia. rollers from 3/4-in. hard maple on my drill press using a fly cutter. You could also cut them on a bandsaw with a circle-cutting jig. I drilled out the centers to 17/32 in., so they would spin on the 1/2-in. hex-head bolts I use as spindles.My rack consists of four evenly spaced blocks attached to uprights and a 4-in.-wide x 6-ft.-long solid-wood backboard. The backboard is screwed tothe wall; the uprights fasten to a board mounted on the ceiling.

Before assembling the rack, I laid out and drilled holes in the uprights and backboard for the hex-head bolts. I counterbored the backboard’s holes for the 1/2-in. nuts that the 7-in.-long bolts screw into. After screwing the blocks to the backboard and installing the nuts, I screwed the assembly to the wall. Then I screwed each upright to the block on the floor and the board on the ceiling. Installing the rollers and their 1/2-in. washer spacers was the last step. I slid them onto the bolts before screwing the bolts into the backboard’s housed nuts.

Click here to read the rest of the article from American Woodworker