American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 
» » ยป

Rough Lumber Cody WY

Looking for Rough Lumber in Cody? We have compiled a list of businesses and services around Cody that should help you with your search. We hope this page helps you find Rough Lumber in Cody.

Gambles
(307) 587-4461
1007 12th Street
Cody, WY
 
Cody Ace Hardware
(307) 587-8555
2201 17th St, K-Mart and McDonald's
Cody, WY
 
Aldrich Home Center Of Cody
(307) 587-2263
308 19th Street
Cody, WY
 
The Home Depot
(307)472-6505
4900 East 2nd Street
Casper, WY
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 7:00am-8:00pm

The Home Depot
(307)686-8128
1105 E Boxelder Road
Gillette, WY
Hours
Mon-Sat: 7:00am-9:00pm
Sun: 7:00am-8:00pm

Titan Truss
(307) 587-2187
2828 Chopper Lane
Cody, WY
 
Bloedorn Lumber Bldg Materials
(307) 587-2223
1902 Big Horn Ave
Cody, WY
 
Diamond Concrete Design
(307) 222-4730
721 15th Street, Suite A
Cody, WY
 
The Home Depot
(307)362-3716
1925 Foothill Blvd
Rock Springs, WY
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 7:00am-8:00pm

The Home Depot
(307)632-2897
1740 Fleischli Pkwy
Cheyenne, WY
Hours
Mon-Sat: 7:00am-9:00pm
Sun: 7:00am-8:00pm

Joint Rough Lumber with a Planer - Techniques - American Woodworker

Joint Rough Lumber with a Planer

I came across some wonderful oak boards for a small table I wanted to build. The problem was the boards were too wide for my jointer and I didn't want to rip them any narrower. I solved my dilemma with this planer sled that allows me to use my planer as a jointer. The trick is to keep the board from rocking during planing. A wood shim under the high corner is all it takes. I add hot-melt glue to the shim and all four corners of the board to keep them from shifting on the sled during planing. Once I have one side planed flat I take the board off the sled, flip it over and plane the other side. The boards for my table were only 4-ft. long and the sled is about 6-in. longer. This technique works equally well for longer boards although you will need a longer sled and you may need additional shims along the sides.


...

Click here to read the rest of the article from American Woodworker