American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 

Router Wrench Risers Arkansas City KS

Fasten a gasket on each side of one wrench with spray adhesive or contact cement. Then use a utility knife to sculpt the opening. The following article has more tips.

Arkansas City-Auth Hometown
(620) 442-1200
2915 N Summitt
Arkansas City, KS
Store Hours
Hometown Dealers
Store Type
Hometown Dealers
Hours
Mon:8.5-18
Tue:8.5-18
Wed:8.5-18
Thu:8.5-18
Fri:8.5-18
Sat:9-18
Sun:12-17
Store Features
Mon:8.5-18
Tue:8.5-18
Wed:8.5-18
Thu:8.5-18
Fri:8.5-18
Sat:9-18
Sun:12-17

Westlake Ace Hardware
(620) 442-1100
2013 Summit Street
Arkansas City, KS
 
Home Lumber Do it center
(620) 221-1860
1201 Main Street
Winfield, KS
 
Houser Hardware & Supply
(580) 362-2422
120 S Main
Newkirk, OK
 
Woodcraft - Lenexa/Kansas City, KS
(913) 599-2800
8645 Bluejacket Road
Lenexa, KS

Data Provided by:
Fastenal- Arkansas City
620-741-0869
1700 N. Summit Arkansas City, KS, 67005
Arkansas City, KS
 
Winfield - Auth Hometown
(620) 221-1200
912 Main St
Winfield, KS
Store Hours
Hometown Dealers
Store Type
Hometown Dealers
Hours
Mon:9-18
Tue:9-18
Wed:9-18
Thu:9-18
Fri:9-18
Sat:9-18
Sun:12-17
Store Features
Mon:9-18
Tue:9-18
Wed:9-18
Thu:9-18
Fri:9-18
Sat:9-18
Sun:12-17

Hometown True Value
(620) 221-0770
718 Main St
Winfield, KS
 
The Home Depot
(785)625-0044
1310 E 41st Street
Hays, KS
Hours
Mon-Sat: 6:00am-9:00pm
Sun: 8:00am-8:00pm

The Home Depot
(785)272-5949
5900 SW Huntoon
Topeka, KS
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Data Provided by:

Router Wrench Risers

Router Wrench Risers

Trying to keep the wrenches that came with my router in position for tightening or loosening the collet used to drive me crazy. The nuts are so widely spaced that the slim wrenches would often slip out of place. 

Fortunately, I discovered a solution at my local hardware store: basin mack gaskets, which are stepped rubber washers used while installing sinks. 

Fasten a gasket on each side of one wrench with spray adhesive or contact cement. Then use a utility knife to sculpt the opening. 

During use, the gasket-covered wrench goes on the shaft nut. One gasket holds this wrench away from the motor housing. The other gasket acts as a platform for the wrench that goes on the collet nut. If the gaskets are too thick to properly align the wrenches, just slice them thinner. One side of this wrench works for tightening; flip it over for loosening. 

Click here to read the rest of the article from American Woodworker