American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 
» » »

Router Wrench Risers Boise ID

Fasten a gasket on each side of one wrench with spray adhesive or contact cement. Then use a utility knife to sculpt the opening. The following article has more tips.

The Home Depot
(208)388-8500
3639 E Federal Way
Boise, ID
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Woodcraft - Boise, ID
(208) 338-1190
6883 West Overland Road
Boise, ID

Data Provided by:
The Home Depot
(208)887-9699
1100 S Progress
Meridian, ID
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(208)461-6476
2003 N Cassia St
Nampa, ID
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Norco
(208) 336-1643
1125 West Amity Rd Boise, ID, 83705
Boise, ID
 
The Home Depot
(208) 388-8500
3639 S Federal Way
Boise, ID
 
The Home Depot
(208)375-1186
1200 Milwaukee Street
Boise, ID
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(208)939-7648
2808 E State Street
Eagle, ID
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Fastenal- Boise
208-363-7155
2506 Orchard Boise, ID, 83705
Boise, ID
 
KC Tool Supply/Boise
(203) 375-1313
5103 Irving St Boise, ID, 83706
Boise, ID
 
Data Provided by:

Router Wrench Risers

Router Wrench Risers

Trying to keep the wrenches that came with my router in position for tightening or loosening the collet used to drive me crazy. The nuts are so widely spaced that the slim wrenches would often slip out of place. 

Fortunately, I discovered a solution at my local hardware store: basin mack gaskets, which are stepped rubber washers used while installing sinks. 

Fasten a gasket on each side of one wrench with spray adhesive or contact cement. Then use a utility knife to sculpt the opening. 

During use, the gasket-covered wrench goes on the shaft nut. One gasket holds this wrench away from the motor housing. The other gasket acts as a platform for the wrench that goes on the collet nut. If the gaskets are too thick to properly align the wrenches, just slice them thinner. One side of this wrench works for tightening; flip it over for loosening. 

Click here to read the rest of the article from American Woodworker