American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 
» » »

Router Wrench Risers Clanton AL

Fasten a gasket on each side of one wrench with spray adhesive or contact cement. Then use a utility knife to sculpt the opening. The following article has more tips.

Russell Do it center
(205) 755-6690
2207 7th Street North
Clanton, AL
 
Clanton Ace Hardware & Building
(205) 755-5500
202 6th St S
Clanton, AL
 
Southern Accents Architectural Antiques, Inc.
(256) 737-0554
308 2nd Ave. SE
Cullman, AL

Data Provided by:
The Home Depot
(205)781-0110
6405 Flintridge Drive
Fairfield, AL
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(256)881-8270
10012 S Memorial Pkwy
Huntsville, AL
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Clanton - Auth Hometown
(205) 755-7890
1605 7Th St N
Clanton, AL
Store Hours
Hometown Dealers
Store Type
Hometown Dealers
Hours
Mon:8-17
Tue:8-17
Wed:8-17
Thu:8-17
Fri:8-17
Sat:8-17
Sun:0-0
Store Features
Mon:8-17
Tue:8-17
Wed:8-17
Thu:8-17
Fri:8-17
Sat:8-17
Sun:0-0

The Home Depot
(251)634-0351
755 Schillinger Rd S
Mobile, AL
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(205)595-7780
7001 Crestwood Blvd
Birmingham, AL
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(205)661-9415
1600 Gadsden Hwy
Trussville, AL
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(205)338-1070
289 Vaughan Lane
Pell City, AL
Hours
Mon-Sat: 7:00am-9:00pm
Sun: 8:00am-7:00pm

Data Provided by:

Router Wrench Risers

Router Wrench Risers

Trying to keep the wrenches that came with my router in position for tightening or loosening the collet used to drive me crazy. The nuts are so widely spaced that the slim wrenches would often slip out of place. 

Fortunately, I discovered a solution at my local hardware store: basin mack gaskets, which are stepped rubber washers used while installing sinks. 

Fasten a gasket on each side of one wrench with spray adhesive or contact cement. Then use a utility knife to sculpt the opening. 

During use, the gasket-covered wrench goes on the shaft nut. One gasket holds this wrench away from the motor housing. The other gasket acts as a platform for the wrench that goes on the collet nut. If the gaskets are too thick to properly align the wrenches, just slice them thinner. One side of this wrench works for tightening; flip it over for loosening. 

Click here to read the rest of the article from American Woodworker