American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 

Router Wrench Risers Grants Pass OR

Fasten a gasket on each side of one wrench with spray adhesive or contact cement. Then use a utility knife to sculpt the opening. The following article has more tips.

Fastenal- Grants Pass
541-472-1746
1470 SE M St Suite 2A Grants Pass, OR, 97526
Grants Pass, OR
 
Farmers Building Supply, Inc
(541) 476-0851
1741 Dowell Rd
Grants Pass, OR
 
Farner Building Supply
541-244-2428
1741 Dowell Rd Grants Pass, OR, 97527
Grants Pass, OR
 
Main Building Supply
(541) 582-0577
Main & Broadway, Corner of Main and Broadway
Rogue River, OR
 
The Home Depot
(541)344-1312
1045 Green Acres Rd
Eugene, OR
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 7:00am-8:00pm

Farmer's Do it Best Feed & Pet
(541) 476-0402
1741 Dowell Rd
Grants Pass, OR
 
Grants Pass - Auth Hometown
(541) 471-9489
1551 Northeast F St
Grants Pass, OR
Store Hours
Hometown Dealers
Store Type
Hometown Dealers
Hours
Mon:9-18
Tue:9-18
Wed:9-18
Thu:9-18
Fri:9-18
Sat:9-18
Sun:10-16
Store Features
Mon:9-18
Tue:9-18
Wed:9-18
Thu:9-18
Fri:9-18
Sat:9-18
Sun:10-16

Fields Home Center
(541) 862-2111
5285 Williams Hwy, Murphy
Grants Pass, OR
 
Woodcrafters
(800) 777-3709
212 NE 6th Ave
Portland, OR

Data Provided by:
Columbia Riverwood
(503) 224-9924
1017 SW Morrison St P.O. Box 10461
Portland, OR

Data Provided by:
Data Provided by:

Router Wrench Risers

Router Wrench Risers

Trying to keep the wrenches that came with my router in position for tightening or loosening the collet used to drive me crazy. The nuts are so widely spaced that the slim wrenches would often slip out of place. 

Fortunately, I discovered a solution at my local hardware store: basin mack gaskets, which are stepped rubber washers used while installing sinks. 

Fasten a gasket on each side of one wrench with spray adhesive or contact cement. Then use a utility knife to sculpt the opening. 

During use, the gasket-covered wrench goes on the shaft nut. One gasket holds this wrench away from the motor housing. The other gasket acts as a platform for the wrench that goes on the collet nut. If the gaskets are too thick to properly align the wrenches, just slice them thinner. One side of this wrench works for tightening; flip it over for loosening. 

Click here to read the rest of the article from American Woodworker