American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 

Router Wrench Risers Marshalltown IA

Fasten a gasket on each side of one wrench with spray adhesive or contact cement. Then use a utility knife to sculpt the opening. The following article has more tips.

Fastenal- Marshalltown
641-752-9674
1309 Industrial Blvd Suite B Marshalltown, IA, 50158
Marshalltown, IA
 
Spahn & Rose Lumber Co.
(641) 752-1541
110 W Madison
Marshalltown, IA
 
True Value Hardware
(641) 486-2268
Center & Union
Union, IA
 
True Value Hardware
(800) 642-7392
Center & Union
Union, IA

Data Provided by:
Hartzell Wood Stock
(563) 566-2298
111 Center Street P.O. Box 176
Lime Springs, IA

Data Provided by:
Kmart 7583 / Cross Merch
(641) 753-0945
1720 S Center St
Marshalltown, IA
Store Hours
Miscellaneous
Store Type
Miscellaneous
Hours
Monday To Friday Working Hours is :8-22 and for Sat:8-22
Sun:8-21
Store Features
Monday To Friday Working Hours is :8-22 and for Sat:8-22
Sun:8-21

Marshalltown -Auth Hometown
(641) 752-8888
507 Iowa Ave W
Marshalltown, IA
Store Hours
Hometown Dealers
Store Type
Hometown Dealers
Hours
Mon:9-18
Tue:9-18
Wed:9-18
Thu:9-18
Fri:9-18
Sat:9-18
Sun:12-17
Store Features
Mon:9-18
Tue:9-18
Wed:9-18
Thu:9-18
Fri:9-18
Sat:9-18
Sun:12-17

Spahn & Rose Lumber Co.
(641) 484-3060
207 State St.
Tama, IA
 
Wilkerson Hardware
(800) 642-7392
129 E High St
Toledo, IA

Data Provided by:
Scandinavian Woodshop /Sawmill
(515) 548-3449
2835 Baxter Avenue
Somers, IA

Data Provided by:
Data Provided by:

Router Wrench Risers

Router Wrench Risers

Trying to keep the wrenches that came with my router in position for tightening or loosening the collet used to drive me crazy. The nuts are so widely spaced that the slim wrenches would often slip out of place. 

Fortunately, I discovered a solution at my local hardware store: basin mack gaskets, which are stepped rubber washers used while installing sinks. 

Fasten a gasket on each side of one wrench with spray adhesive or contact cement. Then use a utility knife to sculpt the opening. 

During use, the gasket-covered wrench goes on the shaft nut. One gasket holds this wrench away from the motor housing. The other gasket acts as a platform for the wrench that goes on the collet nut. If the gaskets are too thick to properly align the wrenches, just slice them thinner. One side of this wrench works for tightening; flip it over for loosening. 

Click here to read the rest of the article from American Woodworker