American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 

Router Wrench Risers Park Hills MO

Fasten a gasket on each side of one wrench with spray adhesive or contact cement. Then use a utility knife to sculpt the opening. The following article has more tips.

Holekamp Do it center
(573) 358-3371
317 N Division
Bonne Terre, MO
 
LOWE'S OF FARMINGTON, MO
573 701-8200
625 WEST KARSCH BOULEVARD FARMINGTON, MO, 63640
Farmington, MO
 
Farmington Building Supply Co.
(573) 756-5705
306 East Karsch Blvd.
Farmington, MO
 
Fastenal- Farmington
573-756-0368
424 N. Washington St Farmington, MO, 63640
Farmington, MO
 
Boyer Do it Best Lumber
(573) 438-5461
208 West High Street
Potosi, MO
 
ABC Supply Co.,Inc/Farmington
573-431-7076
190 Busenbark Place Farmington, MO, 63640
Farmington, MO
 
Plummer's Hardware
(573) 756-6001
101 E Liberty
Farmington, MO
 
Lowe's
(573) 701-8200
625 West Karsch Boulevard
Farmington, MO
Hours
M-SA 7 am - 9 pm
SU 9 am - 7 pm

Maple Valley Ctr
(573) 760-1502
738 Market St
Farmington, MO
Store Hours
Hometown Dealers
Store Type
Hometown Dealers
Hours
Mon:9-18
Tue:9-18
Wed:9-18
Thu:9-18
Fri:9-18
Sat:9-18
Sun:11-16
Store Features
Mon:9-18
Tue:9-18
Wed:9-18
Thu:9-18
Fri:9-18
Sat:9-18
Sun:11-16

Dickey Bub True Value
(573) 436-1177
708 High Street E
Potosi, MO
 

Router Wrench Risers

Router Wrench Risers

Trying to keep the wrenches that came with my router in position for tightening or loosening the collet used to drive me crazy. The nuts are so widely spaced that the slim wrenches would often slip out of place. 

Fortunately, I discovered a solution at my local hardware store: basin mack gaskets, which are stepped rubber washers used while installing sinks. 

Fasten a gasket on each side of one wrench with spray adhesive or contact cement. Then use a utility knife to sculpt the opening. 

During use, the gasket-covered wrench goes on the shaft nut. One gasket holds this wrench away from the motor housing. The other gasket acts as a platform for the wrench that goes on the collet nut. If the gaskets are too thick to properly align the wrenches, just slice them thinner. One side of this wrench works for tightening; flip it over for loosening. 

Click here to read the rest of the article from American Woodworker