American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 
» » »

Router Wrench Risers Stafford VA

Fasten a gasket on each side of one wrench with spray adhesive or contact cement. Then use a utility knife to sculpt the opening. The following article has more tips.

The Home Depot
(540)657-6478
305 Worth Road
Stafford, VA
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(540)785-8871
5771 Plank Road
Fredericksburg, VA
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Lowe's
(540) 242-6000
1330 Stafford Market Place
Stafford, VA
Hours
M-SA 6 am - 10 pm
SU 8 am - 8 pm

Lowe's
(540) 371-2686
299 Banks Ford Parkway
Fredericksburg, VA
Hours
M-SA 6 am - 10 pm
SU 8 am - 8 pm

Mid Atlantic Fasteners- Fredericksburg
540-371-9206
1319 Lafayette Blvd Fredericksburg, VA, 22401
Fredericksburg, VA
 
The Home Depot
(540)368-0515
1201 Gateway Blvd
Fredericksburg, VA
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(703)670-3699
14025 Foulger Square
Woodbridge, VA
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Sears Home Appliance Showroom
(540) 720-6080
1475 Stafford Market Place
Stafford, VA
Store Hours
Hometown Dealers
Store Type
Hometown Dealers
Hours
Mon:10-21
Tue:10-21
Wed:10-21
Thu:10-21
Fri:10-21
Sat:10-21
Sun:11-19
Store Features
Mon:10-21
Tue:10-21
Wed:10-21
Thu:10-21
Fri:10-21
Sat:10-21
Sun:11-19

LOWE'S OF FREDERICKSBURG, VA.
540 786-9050
1361 CARL D. SILVER PKWY FREDERICKSBURG, VA, 22401
Fredericksburg, VA
 
Lowe's
(540) 786-9050
1361 Carl D. Silver Pkwy
Fredericksburg, VA
Hours
M-SA 6 am - 10 pm
SU 8 am - 8 pm

Router Wrench Risers

Router Wrench Risers

Trying to keep the wrenches that came with my router in position for tightening or loosening the collet used to drive me crazy. The nuts are so widely spaced that the slim wrenches would often slip out of place. 

Fortunately, I discovered a solution at my local hardware store: basin mack gaskets, which are stepped rubber washers used while installing sinks. 

Fasten a gasket on each side of one wrench with spray adhesive or contact cement. Then use a utility knife to sculpt the opening. 

During use, the gasket-covered wrench goes on the shaft nut. One gasket holds this wrench away from the motor housing. The other gasket acts as a platform for the wrench that goes on the collet nut. If the gaskets are too thick to properly align the wrenches, just slice them thinner. One side of this wrench works for tightening; flip it over for loosening. 

Click here to read the rest of the article from American Woodworker