American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 

Sharpening Jig Lincoln NE

When making this sharpening jig it’s important to make the slots at the correct angle so the bevels of the blades lay perfectly horizontal. This way the sandpaper will have even contact. Here you will learn how to make your own shop made jigs for woodworking. You also get the option of choosing to buy one of the many different sharpening jig power tools at the hardware supply stores in Lincoln, NE listed below.

The Home Depot
(402) 325-6200
3300 N 27th St
Lincoln, NE
 
The Home Depot
(402)328-9669
6800 South 70th Street
Lincoln, NE
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Murphys Q P Store
(402) 466-9852
1554 N. 48th
Lincoln, NE
 
ABC Supply Co.,Inc/Lincoln
402-477-7300
1001 Y Street Lincoln, NE, 68508
Lincoln, NE
 
Q P Ace Hardware
(402) 438-5517
945 S 27th St
Lincoln, NE
 
The Home Depot
(402)325-6200
3300 N 27th Street
Lincoln, NE
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Westlake Ace Hardware
(402) 466-2623
4545 Vine St
Lincoln, NE
 
Gateway Center 162
(402) 465-3300
6400 O St
Lincoln, NE
Store Hours
Sears Stores
Store Type
Sears Stores
Hours
Mon:10-21
Tue:10-21
Wed:10-21
Thu:10-21
Fri:10-21
Sat:9-21
Sun:11-18
Store Features
Mon:10-21
Tue:10-21
Wed:10-21
Thu:10-21
Fri:10-21
Sat:9-21
Sun:11-18

Baker Hardware
(402) 475-4081
801 N St, WEST HAYMARKET
Lincoln, NE
 
Toofast Supply
(402) 435-3100
2130 Cornhusker Hwy
Lincoln, NE
 

Sharpening Jig

Simple Sharpening Jig

I’ve tried several different shop-made jigs for sharpening my jointer and planer knives but this one has proved the simplest to use and make. 

When making this sharpening jig it’s important to make the slots at the correct angle so the bevels of the blades lay perfectly horizontal. This way the sandpaper will have even contact. My jointer blades required a 38-degree angle but check yours because it may be different. 

I also had to saw the angled slots with the board on its edge. That’s because my tablesaw (like most) tilts to only 45 degrees. This is not far enough for the slot to be cut with the board laying flat. Cutting it on its edge solves this problem. Take a look at your saw and you will see what I mean. Double-check the angle of your jointer knives and saw the slots to match. I added a blade guard to keep things safe.

For the sanding block I used chunks of 3/4-in. MDF with sheets of silicon carbide sandpaper attached with spray-on adhesive. I started with 220 grit and worked my way up to 600 grit for a final honing. 


Click here to read the rest of the article from American Woodworker