American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 

Sharpening Jig Napoleon OH

When making this sharpening jig it’s important to make the slots at the correct angle so the bevels of the blades lay perfectly horizontal. This way the sandpaper will have even contact. Here you will learn how to make your own shop made jigs for woodworking. You also get the option of choosing to buy one of the many different sharpening jig power tools at the hardware supply stores in Napoleon, OH listed below.

Kurtz Ace Hardware
(419) 592-4488
734 N Perry St, before you order online--call the store
Napoleon, OH
 
Fastenal- Wauseon
419-335-0758
1369 N. Shoop Ave Wauseon, OH, 43567
Wauseon, OH
 
Lowe's
(419) 782-9000
1831 North Clinton Street
Defiance, OH
Hours
M-SA 7 am - 9 pm
SU 8 am - 8 pm

Fastenal- Defiance
419-782-9591
1503 Baltimore Rd Defiance, OH, 43512
Defiance, OH
 
Shorts Do it Best
(419) 682-4231
115 W Depot St
Stryker, OH
 
Ace Hardware
(419) 335-1717
1495 N Shoop Ave
Wauseon, OH
 
LOWE'S OF DEFIANCE, OH.
419 782-9000
1831 NORTH CLINTON ST. DEFIANCE, OH, 43512
Defiance, OH
 
Arps Hardware, Lawn & Garden
(419) 782-1171
1400 S. Clinton
Defiance, OH
 
Northtown Mall
(419) 783-2900
1500 N Clinton St
Defiance, OH
Store Hours
Sears Stores
Store Type
Sears Stores
Hours
Mon:10-21
Tue:10-21
Wed:10-21
Thu:10-21
Fri:10-21
Sat:10-21
Sun:12-18
Store Features
Mon:10-21
Tue:10-21
Wed:10-21
Thu:10-21
Fri:10-21
Sat:10-21
Sun:12-18

Affiliated Cash & Carry
(419) 826-5866
5751 County Road 3
Swanton, OH
 

Sharpening Jig

Simple Sharpening Jig

I’ve tried several different shop-made jigs for sharpening my jointer and planer knives but this one has proved the simplest to use and make. 

When making this sharpening jig it’s important to make the slots at the correct angle so the bevels of the blades lay perfectly horizontal. This way the sandpaper will have even contact. My jointer blades required a 38-degree angle but check yours because it may be different. 

I also had to saw the angled slots with the board on its edge. That’s because my tablesaw (like most) tilts to only 45 degrees. This is not far enough for the slot to be cut with the board laying flat. Cutting it on its edge solves this problem. Take a look at your saw and you will see what I mean. Double-check the angle of your jointer knives and saw the slots to match. I added a blade guard to keep things safe.

For the sanding block I used chunks of 3/4-in. MDF with sheets of silicon carbide sandpaper attached with spray-on adhesive. I started with 220 grit and worked my way up to 600 grit for a final honing. 


Click here to read the rest of the article from American Woodworker