American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 

Swingin' Storage Park Hills MO

To install a panel, insert the longer dowel in the top tool holder until the bottom;dowel;slips into the bottom tool holder. The long top dowel; must extend through both rings of the tool holder to keep the panel from falling out.

Holekamp Do it center
(573) 358-3371
317 N Division
Bonne Terre, MO
 
Fastenal- Farmington
573-756-0368
424 N. Washington St Farmington, MO, 63640
Farmington, MO
 
Maple Valley Ctr
(573) 760-1502
738 Market St
Farmington, MO
Store Hours
Hometown Dealers
Store Type
Hometown Dealers
Hours
Mon:9-18
Tue:9-18
Wed:9-18
Thu:9-18
Fri:9-18
Sat:9-18
Sun:11-16
Store Features
Mon:9-18
Tue:9-18
Wed:9-18
Thu:9-18
Fri:9-18
Sat:9-18
Sun:11-16

Plummer's Hardware
(573) 756-6001
101 E Liberty
Farmington, MO
 
Dickey Bub True Value
(573) 436-1177
708 High Street E
Potosi, MO
 
LOWE'S OF FARMINGTON, MO
573 701-8200
625 WEST KARSCH BOULEVARD FARMINGTON, MO, 63640
Farmington, MO
 
Farmington Building Supply Co.
(573) 756-5705
306 East Karsch Blvd.
Farmington, MO
 
ABC Supply Co.,Inc/Farmington
573-431-7076
190 Busenbark Place Farmington, MO, 63640
Farmington, MO
 
Lowe's
(573) 701-8200
625 West Karsch Boulevard
Farmington, MO
Hours
M-SA 7 am - 9 pm
SU 9 am - 7 pm

Boyer Do it Best Lumber
(573) 438-5461
208 West High Street
Potosi, MO
 

Swingin' Storage

Swingin' Storage



I like to store hardware in its original package on a Peg-Board wall in my shop. I've devised some swinging panels for the wall that give me a lot more usable space. To make the panels, you'll need 1/8" Peg-Board, a 3/4" dia. dowel rod, and Peg-Board tool holders.

Make the panels by cutting 12" x 12" pieces from the Peg-Board. For each panel, cut one dowel 2-1/2" long and one 5" long. Cut a 1/8" wide groove in one end of both dowels and slide the dowels onto the panels. Fasten the dowels with screws. 


To install a panel, insert the longer dowel in the top tool holder until the bottom dowel slips into the bottom tool holder. The long top dowel must extend through both rings of the tool holder to keep the panel from falling out. Each pair of tool holders holds up to six panels. 

I also cut a 1/8" wide slot in a 12" length of 2x4 to use as a base for the panels so I can remove a panel from the tool rack and set it on my workbench.

--Mark Thiel



Click here to read the rest of the article from American Woodworker