American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 
» » »

The Shadow Knows Baker LA

. Like many lasers, the shadow shows you exactly where the blade is going to cut. But there's a catch with lasers: most of them only show you where one side of the blade will cut. The shadow shows the entire kerf, so it doesn't matter whether your waste piece is on the left or right side of the blade.

The Home Depot
(225)658-2592
6600 Main Street
Zachary, LA
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(225) 201-1778
8181 Airline Hwy
Baton Rouge, LA
 
The Home Depot
(225)664-3656
2255 Home Depot Dr
Denham Springs, LA
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Baker Hardware
(225) 775-1221
6655 Lavey Lane
Baker, LA
 
Le Blancs' Ace Hardware
(225) 658-2784
2300 Church St
Zachary, LA
 
The Home Depot
(225)201-1778
8181 Airline Highway
Baton Rouge, LA
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(225)293-9629
10300 Coursey Blvd
Baton Rouge, LA
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(225)755-1729
18139 Highland Rd
Baton Rouge, LA
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Acadian True Value Hdwe
(225) 355-8270
7350 Scenic Hwy
Baton Rouge, LA
 
Pelican State Supply
(225) 354-7916
2540 Scenic Hwy
Baton Rouge, LA
 

The Shadow Knows

The Shadow Knows

 

    

Miter saws equipped with lasers to indicate the line of cut have become commonplace, but DeWalt has a new twist: instead of a laser, DeWalt has developed a super-bright LED light to cast a distinct shadow of the blade on your workpiece. Like many lasers, the shadow shows you exactly where the blade is going to cut. But there's a catch with lasers: most of them only show you where one side of the blade will cut. The shadow shows the entire kerf, so it doesn't matter whether your waste piece is on the left or right side of the blade. And unlike some lasers, this light doesn't have to be aimed–the blade's shadow is always right on the money. DeWalt calls this feature the XPS Worklight. It's available as an accessory for the DW713, DW715, DW716 and DW718 miter saws. Mounting is a cinch; it only takes a few minutes. The light has a separate on/off switch, so the blade doesn't have to be running while you position your workpiece. The one downside–and this is really a minor point–is that the blade must be placed an inch or so above the workpiece for the shadow to pop into sharp focus. DeWalt says that the light bulb should last up to 5 years. That's great, because even if you don't use the shadow technique, the light really illuminates the cut zone, making it much easier to see a fine pencil mark on your work.

Source
DeWalt, www.dewalt.com, 800-433-9258, Miter Saw LED Worklight System, #DWS7085, $60.


Click here to read the rest of the article from American Woodworker