American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 
» » »

The Shadow Knows Cody WY

. Like many lasers, the shadow shows you exactly where the blade is going to cut. But there's a catch with lasers: most of them only show you where one side of the blade will cut. The shadow shows the entire kerf, so it doesn't matter whether your waste piece is on the left or right side of the blade.

Cody Ace Hardware
(307) 587-8555
2201 17th St, K-Mart and McDonald's
Cody, WY
 
Aldrich Home Center Of Cody
(307) 587-2263
308 19th Street
Cody, WY
 
Titan Truss
(307) 587-2187
2828 Chopper Lane
Cody, WY
 
The Home Depot
(307)674-6669
2050 Coffeen Avenue
Sheridan, WY
Hours
Mon-Sat: 7:00am-8:00pm
Sun: 8:00am-8:00pm

The Home Depot
(307)686-8128
1105 E Boxelder Road
Gillette, WY
Hours
Mon-Sat: 7:00am-9:00pm
Sun: 7:00am-8:00pm

Bloedorn Lumber Bldg Materials
(307) 587-2223
1902 Big Horn Ave
Cody, WY
 
Gambles
(307) 587-4461
1007 12th Street
Cody, WY
 
Diamond Concrete Design
(307) 222-4730
721 15th Street, Suite A
Cody, WY
 
The Home Depot
(307)472-6505
4900 East 2nd Street
Casper, WY
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 7:00am-8:00pm

The Home Depot
(307)632-2897
1740 Fleischli Pkwy
Cheyenne, WY
Hours
Mon-Sat: 7:00am-9:00pm
Sun: 7:00am-8:00pm

The Shadow Knows

The Shadow Knows

 

    

Miter saws equipped with lasers to indicate the line of cut have become commonplace, but DeWalt has a new twist: instead of a laser, DeWalt has developed a super-bright LED light to cast a distinct shadow of the blade on your workpiece. Like many lasers, the shadow shows you exactly where the blade is going to cut. But there's a catch with lasers: most of them only show you where one side of the blade will cut. The shadow shows the entire kerf, so it doesn't matter whether your waste piece is on the left or right side of the blade. And unlike some lasers, this light doesn't have to be aimed–the blade's shadow is always right on the money. DeWalt calls this feature the XPS Worklight. It's available as an accessory for the DW713, DW715, DW716 and DW718 miter saws. Mounting is a cinch; it only takes a few minutes. The light has a separate on/off switch, so the blade doesn't have to be running while you position your workpiece. The one downside–and this is really a minor point–is that the blade must be placed an inch or so above the workpiece for the shadow to pop into sharp focus. DeWalt says that the light bulb should last up to 5 years. That's great, because even if you don't use the shadow technique, the light really illuminates the cut zone, making it much easier to see a fine pencil mark on your work.

Source
DeWalt, www.dewalt.com, 800-433-9258, Miter Saw LED Worklight System, #DWS7085, $60.


Click here to read the rest of the article from American Woodworker