American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 

Versatile Router-Bit Storage Vincennes IN

Versatile router-bit storage is not that hard to make. The following article has 8 tips to offer to help you build your own tool stand. So read on to get more detailed instruction below.

Vincennes - Auth Hometown
(812) 886-0669
1815 N 6Th St
Vincennes, IN
Store Hours
Hometown Dealers
Store Type
Hometown Dealers
Hours
Mon:9-19
Tue:9-19
Wed:9-19
Thu:9-19
Fri:9-19
Sat:9-18
Sun:12-17
Store Features
Mon:9-19
Tue:9-19
Wed:9-19
Thu:9-19
Fri:9-19
Sat:9-18
Sun:12-17

LOWE'S OF VINCENNES, IN
812 895-0538
2700 NORTH 6TH STREET VINCENNES, IN, 47591
Vincennes, IN
 
Niehaus Home Center
(812) 882-2710
1023-1025 Main St
Vincennes, IN
 
Bender Lumber
(812) 254-7774
2112 East State
Washington, IN
 
Lawrence County Ace Hardware
(618) 943-3762
2401 James St
Lawrenceville, IL
 
Fastenal- Vincennes
812-886-5877
2803 North 6th Street Vincennes, IN, 47591
Vincennes, IN
 
Lowe's
(812) 895-0538
2700 North 6Th Street
Vincennes, IN
Hours
M-SA 7 am - 9 pm
SU 9 am - 7 pm

Mackey's Do it Best Hardware
(812) 735-2779
321 N Main Street
Bicknell, IN
 
Greenwood Hardware Inc
(812) 254-1734
708 E Main St
Washington, IN
 
Petersburg Hardware
(812) 354-8350
105 N 5th Street
Petersburg, IN
 

Versatile Router-Bit Storage

Versatile Router-Bit Storage

When it comes to router-bit storage, I could write a book. I’ve tried everything, but I think my latest design is a keeper. 

I prefer to keep my bits protected in a drawer. At first, I just drilled some holes in a block of MDF and set that into the drawer. But it proved difficult to thread my hand through the forest of sharp carbide when reaching for a bit. Several bandages later, I had a better idea. I cut 3/4-in. MDF into square blocks small enough to fit in a row inside the drawer but big enough to hold my panel-raiser bit. I left about 1/16 in. of clearance around each block so I can easily lift them in and out. It’s best to keep the blocks square, so you don’t have to turn one this way or that to fit it in its space. I drilled holes for the 1/2-in. shanks using a 33/64-in. twist bit and for 1/4-in. shanks using a 17/64-in. bit. The slightly oversize holes allow the bits to slip easily in and out. 

To avoid reaching into the sharp bits, I cut some 5/16-in. dowel stock to make handles for lifting the blocks. The knobs at the top are made from 3/4-in. wooden balls I picked up at a craft and hobby store. Now it’s easy to select just the bit I want and take it right to the router table.

Click here to read the rest of the article from American Woodworker