American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 
» » »

Woodworking Panels Apex NC

Looking for Woodworking Panels in Apex? We have compiled a list of businesses and services around Apex that should help you with your search. We hope this page helps you find Woodworking Panels in Apex.

Robbins Custom Sawing and Lumber for Natural Edge Slabs
(919) 779-0719
2200 Bull Run Drive
Apex, NC

Data Provided by:
The Home Depot
(919)851-5554
2031 Walnut Street
Cary, NC
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(919)661-1393
2540 Timber Dr
Garner, NC
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(919)844-7418
9517 Strickland Rd
Raleigh, NC
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Klingspor’s Woodworking Shop of Raleigh
(919) 876-0707
3141 Capital Blvd.Capital Square
Raleigh, NC

Data Provided by:
The Home Depot
(919)387-6554
1000 Vision Dr
Apex, NC
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(919)552-2881
901 E Broad Street
Fuquay Varina, NC
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Woodcraft - Raleigh/Durham, NC
(919) 781-1911
4317 Pleasant Valley Road
Raleigh, NC

Data Provided by:
The Home Depot
(919)419-0208
3701 MT Moriah Road
Durham, NC
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(919)217-3093
1020 Shopps At Midway
Knightdale, NC
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Data Provided by:

Good-Looking Panels - Tips - American Woodworker

Good-Looking Panels

Nothing makes a cabinet look worse than door panels with unattractive grain that runs at weird angles. It pays to be picky about grain direction, even if it means wasting some plywood.

After assembling your door frames without glue, slide them around on the sheet  of plywood until they frame attractive panels. Look for symmetrical grain patterns that you can center. Avoid patterns that run off one side. 

I try to find grain that resembles mountains or cathedral arches. These A-shaped patterns make doors and cabinets appear taller and more graceful. Tight grain patterns, where the early and late growth is closely spaced, usually look better than patterns with wide grain. 

Mark your good-looking panels by tracing around the inside of the door frames. Cut out the traced panels at least 1/2 in. larger on all four sides. Then trim them to fit the frames. Use the ugly plywood that’s left over for jigs or in other places where appearance doesn’t matter. ...

Click here to read the rest of the article from American Woodworker