American Woodworker
Contact Us | Help | Report a Bug
Sign in | Join
 

Woodworking Panels Los Alamos NM

Looking for Woodworking Panels in Los Alamos? We have compiled a list of businesses and services around Los Alamos that should help you with your search. We hope this page helps you find Woodworking Panels in Los Alamos.

Metzger's Do it Best Hardware
(505) 662-3715
1607 Central Avenue
Los Alamos, NM
 
Hacienda Home Centers
(505) 753-2131
430 S Riverside Drive
Espanola, NM
 
Cooks True Value Hardware
(800) 642-7392
518 Paseo De Onate
Espanola, NM

Data Provided by:
The Home Depot
(505)424-9463
952 Richards Ave
Santa Fe, NM
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 7:00am-8:00pm

The Home Depot
(505)271-1900
200 Eubank Blvd SE
Albuquerque, NM
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 7:00am-8:00pm

Los Alamos Hme Imprvmt Co
(505) 662-5371
232 Dp Rd
Los Alamos, NM
 
Lowe's
(505) 367-1900
407 Lowdermilk Lane
Espanola, NM
Hours
M-SA 7 am - 9 pm
SU 8 am - 8 pm

The Home Depot
(575)492-9117
900 W Joe Harvey Blvd
Hobbs, NM
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

The Home Depot
(575)443-8018
3400 N White Sand Blvd
Alamogordo, NM
Hours
Mon-Sat: 6:00am-10:00pm
Sun: 8:00am-8:00pm

Woodcraft - Albuquerque, NM
(505) 342-9663
4520B Alexander NE
Albuquerque, NM

Data Provided by:
Data Provided by:

Good-Looking Panels - Tips - American Woodworker

Good-Looking Panels

Nothing makes a cabinet look worse than door panels with unattractive grain that runs at weird angles. It pays to be picky about grain direction, even if it means wasting some plywood.

After assembling your door frames without glue, slide them around on the sheet  of plywood until they frame attractive panels. Look for symmetrical grain patterns that you can center. Avoid patterns that run off one side. 

I try to find grain that resembles mountains or cathedral arches. These A-shaped patterns make doors and cabinets appear taller and more graceful. Tight grain patterns, where the early and late growth is closely spaced, usually look better than patterns with wide grain. 

Mark your good-looking panels by tracing around the inside of the door frames. Cut out the traced panels at least 1/2 in. larger on all four sides. Then trim them to fit the frames. Use the ugly plywood that’s left over for jigs or in other places where appearance doesn’t matter. ...

Click here to read the rest of the article from American Woodworker